BISTRO SERIESStone Hearth Cooking ApplianceRevised July 2010WOOD STONE CORPORATION 1801 W. Bakerview Rd.Bellingham, WA 98226 USAToll Free (800) 578-
Once you have moved the appliance to where it will be installed, go to Step 11 on page 20 for instructions regarding electrical and gas connections.CA
IF YOU NEED TO DISASSEMBLE THE APPLIANCE TO MOVE IT THROUGH A NARROW DOOR ORPASSAGEWAY...Unplug thermocouple wire and coil it to prevent damage while
2. Remove the (3) cap nuts that hold the mantle in place, and remove the mantle. It may be necessary to cut the silicone at the joint between the mant
Using the upper forklift pockets support the appliance with a forklift or other suitable device. Remove the bolts that attach the appliance body to th
1. Use a forklift or other suitable lifting means to set the appliance body onto blocks as shown. If the appliance has the optional decorative logset,
5.Using an appropriate hoist or lift, the appliance may now be tilted (on its back) onto a pallet jack or suitable dolly. The appliance can now
All parts shown above and provided with the appliance (except the shipping panel) MUST be installed to ensure the safety and proper operation of the a
Use the 3/8" x 1"carriage bolts to assemble the stand on a level surface. Be sure to use the washers provided and to tighten nuts and bolts
3. Using a forklift, carefully lower the body of the appliance on to the stand so that the bolt holes line up. While supporting the applianc
5. Remove the Shipping Panel from beneath the appliance. The Shipping Panel is secured with (2) screws in the front, and (2) screws in the back. Disca
This page intentionally left blank >
7. Connect burner assembly components and thermocouple at the rear of the control box.Attach flexible pilot tube here. Tighten the fitting firmly.Plug i
If the appliance has been supplied with a granite mantle, affix the granite slab to the mounting bracket using a generous amount of the adhesive provid
10. Reinstall the burner guard, and optional logset if supplied. The lower tab of the guard fits into the front of the burner opening. Check that this
11. Make utility connections, at the rear of the control box. Gas and electrical connections must comply with all relevant national and local codes
12. Checking the burner manifold pressure. The burner manifold pressure has been set at the factory, however it should be checked by the installer. Th
VENTINGWOOD STONE APPLIANCES MUST BE VENTED IN ACCORDANCE WITH NFPA 96, UL 103 AND/OR ALL PERTINENT NATIONAL, REGIONAL AND LOCAL CODES CONCERNING
INITIAL APPLIANCE STARTUPNEVER OPERATE THIS APPLIANCE WITH THE STAINLESS STEEL NIGHT DOOR (OPTIONAL) IN PLACE! THE OPTIONAL NIGHT DOOR IS FOR HE
1. TURNING ON THE APPLIANCEPush I/O button and turn the radiant flame to its highest setting. To set the appliance to turn on automatically using the p
THERMAL CLEANINGGas-fired Appliance- If a Wood Stone gas-fired appliance is operated at low temperatures (below 525 degrees Fahrenheit [F] ), you may no
REMOVAL OF CREOSOTE AND SOOTOnly RFG-W models are intended to allow the additional burning of wood. As with all cooking equipment and solid fuel exhau
3An ongoing program of product improvement may require us to change specifications without notice. BH-RFG, BH-RFG-W. Revised July 2010WOOD STONE CORPOR
'ON/OFF' Button- press to turn appliance on and offTemperature Units- press and hold to switch between Fahrenheit and Celsius.Hearth Tempera
Please contact Wood Stone at 1-800-578-6836 should service be necessary, or if you have any questions about your appliance. Our office hours are 8am to
Wire the incoming 120 volts to the oven J-box as instructed in the 'Assembly' section of this manual.Have the electrician mount the fan cont
CLOCK/TIMER PROGRAMMINGNOTE: If an exhaust fan is installed on the appliance ventilation system, it must be interlocked to the appliance. An unsafe co
TIMER MODE OPERATIONWhen the timer is programmed for 'ON'/'OFF' mode operation and the time of day reaches the programmed 'ON
BISTRO WITH HOT SURFACE IGNITION AND TIMER35 35An ongoing program of product improvement may require us to change specifications without notice. BH-RFG
EXCLUSIONSThe warranties provided by Wood Stone do not apply in the following instances:1. In the event that the equipment is improperly installed. P
INSTALLATION AND OPERATION MANUAL FOR THE WOOD STONE RESIDENTIAL BISTROSTONE HEARTH COOKING APPLIANCEWS-BH-3030-RFG-(NG OR LP), WS-BH-4343-RFG-(NG OR
WOOD STONE RESIDENTIAL BISTRO GAS COOKING APPLIANCE INSTALLATION AND OPERATING INSTRUCTIONSDO NOT THROW THIS MANUAL AWAYRETAIN THIS MANUAL FOR FUTURE
Actual Weight: 850 lbs. Shipping Weight: 1100 lbs. [email protected] or visit www.woodstone-corp.comUTILITIES SPECIFICATIONSGas-3/4 inch FNPT ga
Actual Weight: 1650 lbs. Shipping Weight: 2100 lbs.UTILITIES SPECIFICATIONSGas-3/4 inch gas inlet (female threaded) 80,500 BTU Natural Gas Supply OR
Electrical120 VAC, 2 amp, 50/60 Hz All utility connections made on the back of the appliance control box. Remove front or rear panel for access, use
IF THIS APPLIANCE IS NOT PROPERLY INSTALLED A FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THESE INSTALLATION INSTRUCTIONS. A MAJOR CAUSE OF AP
Comments to this Manuals